综述论文
3.
1.Input Shaft, Circular Spline, and housing must be concentric.
2.The oil drain also enables assembly verification.
3.The Flexspline pilot diameter must be concentric to Circular Spline.
4.A clamping ring with corner radius increases torque transmission capacity and prevents damage to the Flexspline diaphragm.
5.A radial shaft seal for oil lubrication.
阿基米德分牛6.Double bearing support for output shaft.
7.Axial location of Flexspline. 虚幻竞技场2007
8.Air vent depending on the application.
健康之路杂志
9.买淫Flexspline and Circular Spline must be located both parallel and perpendicular to the ou
tput shaft.
10.Axial location of Wave Generator.
数字暗房11.Oil input. (also enables assemble verification)
12.Double bearing support for input shaft.