JMN Specialties, Inc. 1100 Victory Drive
Westwego, LA 70094
(504) 341-3749
ISO 9001 Registered HMIS HEALTH: (2)
HMIS FLAMMABILITY: (1)
HMIS REACTIVITY: 0
PERSONAL PROTECTION:.....C EMERGENCY NUMBER:..........800-255-3924
SECTION 1 – IDENTIFICATION OF CHEMICAL PRODUCT
PRODUCT NAME:......................MIL-C-16173D GRADE 1
EFFECTIVE DATE:....................September 20, 2007
CHEMICAL FAMILY:...............Paraffin Compound FORMULA:..................................Proprietary
CAS NUMBER:............................Blend
SECTION 2 – COMPOSITION / INFORMATION ON INGREDIENTS HAZARDOUS INGREDIENT PERCENT CAS NUMBER PEL Petroleum Asphalt 55 - 75 8052-42-4 5 mg/m3 for mist in air
Light Hydrotreated Distillate35 - 508032-32-4ACGIH TWA 500 ppm,
OSHA TWA 500 ppm The criteria for listing components in the composition section are as follows: Carcinogens are listed when present at 0.1% or greater; components which are otherwise hazardous according to OSHA are listed when present at 1.0% or greater. Non-hazardous components may be listed at 3.0% or greater if not proprietary in nature. This is not intended to be complete compositional disclosure. Refer to section 14 for applicable states right to know and other regulatory information.
SECTION 3 – HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
APPEARANCE / ODOR:............Black Liquid / Aromatic Odor
SHORT TERM EXPOSURE: GENERAL: Solvent vapors may be irritating to skin and eyes.
INHALATION: High concentrations of vapor may cause irritation of
the respiratory tract, experienced as nasal discomfort and discharge,
possibly with chest pain and coughing. NOTICE: Reports have
associated repeated and prolonged occupational overexposure to
solvents with permanent brain and nervous system damage. Intentional
misuse by deliberately concentrating and inhaling this product may be
harmful or fatal. EYES: May cause mild to severe irritation
experienced as discomfort or pain, excess blinking and tear production,
possibly with marked redness and swelling of the conjunctiva. SKIN:
Brief contact may cause slight irritation with itching and local redness.
Prolonged contact may cause more severe irritation, with discomfort or
pain. SWALLOWING: May cause headache, dizziness, nausea,
vomiting, diarrhea, coma, and death.
OSHA REGULATED:.................No
LISTED CARCINOGEN:...........NTP: No IARC MONOGRAPHS: No
PAGE 1 of 6
POTENTIAL HEALTH EFFECTS INHALATION:............................Irritant INGESTION:................................Irritant
SKIN (DERMAL):.......................Irritant
OVER EXPOSURE EFFECTS: Inhalation: Causes irritation to the respiratory tract. Symptoms may
忆韦素园君include coughing, shortness of breath. Ingestion: Causes irritation to
the gastrointestinal tract. Symptoms may include nausea, vomiting and
diarrhea. Skin Contact: May cause irritation to skin. Symptoms
include redness, itching, and pain. Eye Contact: Causes irritation,
redness, and pain. Chronic Exposure: No information found.
Aggravation of Pre-existing Conditions: No information found.
SECTION 4 – FIRST AID MEASURES
CONTACT: Remove contaminated clothing and shoes
FIRST AID: SKIN
immediately. Wash affected area with soap or mild detergent and large
amounts of water until no evidence of chemical remains (at least 15-20
国防minutes). Get medical attention immediately. EYE CONTACT:
Flush eyes immediately with large amounts of water or normal saline
solution, occasionally lifting upper and lower lids until no evidence of
chemical remains (at least 15-20 minutes). Get medical attention
immediately. INGESTION: Give large amounts of fresh water or
测井解释
milk immediately. Do not give anything by mouth if person is
unconscious or otherwise unable to swallow. If vomiting occurs, keep
head below hips to prevent aspiration. Treat symptomatically and
supportively. Seek medical attention immediately. INHALATION:
Remove from exposure area to fresh air immediately. If breathing has
stopped, perform artificial resuscitation. Keep person warm and at rest.
Treat symptomatically and supportively. Seek medical attention
immediately. Qualified medical personnel should consider
administering oxygen.
SECTION 5 - FIRE FIGHTING MEASURES
FLASHPOINT:.............................~ 140° F
EXTINGUISHING MEDIA: Water fog or spray, foam, dry powder, carbon dioxide (CO2) DECOMPOSITION PRODUCTS:.................................From Fire: Smoke, Carbon Dioxide, Carbon Monoxide & Oxides of
Nitrogen
LOWER FLAME LIMIT:...........ND
HIGHER FLAME LIMIT:..........ND
UNUSUAL FIRE AND
EXPLOSION HAZARDS:...........Containers may explode from internal pressure if confined to fire.
Cool with water spray.
FIRE FIGHTING EQUIPMENT:..............................Fire fighters and others exposed to products of co
mbustion should wear
self-contained breathing apparatus. Equipment should be thoroughly
decontaminated after use.
PAGE 2 of 6
SECTION 6 – ACCIDENTAL RELEASE MEASURES
CHEMTEL EMERGENCY
NUMBER (24 Hour):...................1-800-255-3924 SPILL:...........................................In case of spillage, dyke to control spillage and prevent environmental
谢赫
contamination, absorb with inert material and dispose of in accordance
with applicable regulations; if fire potential exists, blanket with foam
as a precaution.
RCRA STATUS:..........................None
SECTION 7 – HANDLING AND STORAGE
HANDLE IN ACCORDANCE WITH GOOD INDUSTRIAL HYGIENE AND SAFETY PRACTICES. THESE PRACTICES INCLUDE AVOIDING UNNECESSARY EXPOSURE AND PROMPT REMOVAL OF MATERIAL FROM EYES, SKIN, AND CLOTHING.
HANDLING AND STORAGE:..Store in a cool place away from ignition sources. Store away from
oxidizers or materials bearing a yellow "DOT" label. PRECAUTIONARY MEASURES:................................Provide fresh air ventilation during and after application. Close
container after each use. Avoid breathing vapors and spray mist. Use
respiratory devices and other personal protection equipment required
by OSHA 29 CFR 1910. Avoid contact with eyes, skin and clothing.
Keep away from heat, sparks and flame.
SECTION 8 – EXPOSURE CONTROL / PERSONAL PROTECTION
GENERAL CONSIDERATIONS:
Consider the potential hazards of this material (see section 3), applicable exposure limits, job activities, and other substances in the work place when designing engineering controls and selecting personal protective equipment.
EYE PROTECTION:...................Chemical safety goggles meeting the specifications of OSHA 29CFR
1910.133 / ANSI Standard Z87.1 should be worn whenever there is the
possibility of splashing or other contact with the eyes. Wear safety
glasses meeting the specifications of OSHA 29CFR 1910.133 / ANSI
Standard Z87.1 where no contact with the eye is anticipated. RESPIRATORY PROTECTION:............................Use NIOSH approved vapor respirator if exposure is unknown or
exceeds permissible limits. A respiratory protection program that meets
OSHA's 29 CFR 1910.134 or ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant respirator use.
Use NIOSH / MSHA approved respiratory protection equipment when airborne exposure limits are exceeded (see below). Consult the respirator manufacturer to determine appropriate type of equipment for a given application. Observe respirator use limitations specified by NIOSH / MSHA or the manufacturer. Respiratory protection programs must comply with 29 CFR 1910.134. WARNING: Air-purifying respirators do not protect workers in oxygen-deficient atmospheres. PROTECTIVE GLOVES:...........Wear impervious gloves
PAGE 3 of 6
VENTILATION: A system of local and/or general exhaust is recommended to keep
employee exposures below the Airborne Exposure Limits. Local
exhaust ventilation is generally preferred because it can control the
emissions of the contaminant at its source, preventing dispersion of it
into the general work area. Please refer to the ACGIH document,
Industrial Ventilation, A Manual of Recommended Practices, most
recent edition, for details.
MECHANICAL EXHAUST:......Desired in closed spaces.
LOCAL EXHAUST:....................Recommended
VENTILATION NOTES: Provide natural or mechanical ventilation to control exposure levels below Airborne exposure limits (see below). The use of local mechanical exhaust ventilation is preferred at sources of air contamination such as open process equipment. Consult NFPA Standard 91 for design of exhaust systems.
THRESHOLD LIMIT VALUE: Suppliers Recommended TLV 5 mg/m3 for mist in air PROTECTIVE EQUIPMENT:...HMIS PERSONAL PROTECTION: C: Safety Glasses, Gloves, Apron The user should read and understand all instructions and limitations supplied with the equipment since protection is usually provided for a limited time or under certain circumstances.
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE / ODOR:............Black Liquid / Aromatic Odor
BOILING POINT:.......................> 300°F
FREEZING POINT:....................< 32°F
VAPOR PRESSURE:...................Unknown
VAPOR DENSITY (AIR=1):......> 1
SPECIFIC GRAVITY:................0.78 - 0.80 pH:.................................................NA
SOLUBILITY IN WATER:........Insoluble
SECTION 10 – STABILITY AND REACTIVITY STABILITY:.................................Stable
HAZARDOUS
POLYMERIZATION:.................Will not occur
POLYMERIZATION AVOID:...None INCOMPATIBILITY:.................Oxidizers or Oxidizing Materials.
CONDITIONS TO AVOID:........Heat, Sparks, and Open Flames
SECTION 11 – TOXICOLOGICAL INFORMATION
EYE EFFECTS:
The eye irritation hazard is based on data from information supplied by raw material(s) supplier(s).
SKIN EFFECTS:
The skin irritation hazard is based on data from information supplied by raw material(s) supplier(s). ACUTE ORAL EFFECTS:
The acute oral toxicity is based on data from information supplied by raw material(s) supplier(s).
ACUTE INHALATION EFFECTS:
The acute respiratory toxicity is based on data from information supplied by raw material(s) supplier(s).
PAGE 4 of 6
SECTION 12 – ECOLOGICAL INFORMATION
Data from laboratory studies and from scientific literature is noted below if available.
SECTION 13 DISPOSAL CONSIDERATIONS
WASTE DISPOSAL:...................Treatment, storage, transportation and disposal must be in accordance
with Federal, State/Provincial and Local Regulations. Regulations may
vary in different locations. Characterization and compliance with
applicable laws are the responsibility solely of the generator. Whatever
cannot be saved for recovery or recycling should be managed in an
directui界面库appropriate and approved waste disposal facility. Processing, use or
contamination of this product may change the waste management
options. State and local disposal regulations may differ from federal
disposal regulations. Dispose of container and unused contents in
accordance with federal, state and local requirements.
SECTION 14- TRANSPORTATION INFORMATION
The data provided in this section is for information only. The description shown may not apply to all shipping situations. Consult 49CFR, or appropriate regulations to properly classify your shipment for transportation.
绝对值电路PROPER SHIPPING NAME:.....DOT Non-Regulated in container size less than 115 gallons or 1001
pounds net weight. In bulk containers larger than 115 gallons or in
excess of 1001 pounds: Combustible Liquid, N.O.S. Contains
(Petroleum Naphtha), 3, UN1268, PG III.
REPORTABLE QUANTITY:.....None
HAZARD CLASS AND LABEL:3, Combustible Liquid
UN NUMBER: (1268)
NA NUMBER:..............................None
PACKAGING SIZE:....................Drum & Bulk
SECTION 15 - REGULATORY INFORMATION
SARA 311 CATEGORIES:
EPA ACUTE:................................Yes
EPA CHRONIC:..........................No
EPA IGNITABILITY:.................Yes
EPA REACTIVITY:....................No
EPA SUDDEN RELEASE
OF PRESSURE:........................... No
CERCLA RQ VALUE:................None
SARA TPQ:..................................None
SARA RQ:.....................................None
EPA HAZARD WASTE #:..........DOO1 - Characteristics of Ignitability
CLEAN AIR:................................NA
CLEAN WATER:.........................NA
PAGE 5 of 6
豫公网安备41160202000603
站长QQ:729038198
关于我们
投诉建议