OPERATION PROCEDURE MANUAL FOR TYPE C 80T AUTOMATIC SPIDER
马恒昌CONTENT
1．SECTION 1 – INTRODUCTION (3)
2. SECTION 2 – OPERATION (4)
3. SECTION 3 –INSTALLATION (5)
4. SECTION4–MAINTENANCE (6)
5.SECTION5–APPENDIX (7)
1 Section1–introduction
THIS MANUAL INCLUDES OPERATION AND MAINTENANCE INSTRUCTIONS FOR
TYPE C 80T AUTOMATIC SPIDER WITH COMPLETE PRATS LISTS.可必特
Product description ：
TYPE C 80T automatic spiders are suitable for the tubing range from 2-3/8” to 5”
(60.33mm-127mm). The gate opening is 6” (152mm). The bowl opening is 6
5/8”(168mm) It is designed for pneumatic or manually operating.
Specifications for Model “C” Spiders – 80Ton
SPECIFICATIONS C
HEIGHT 17-1/8"（435mm）
BASE DIMENSION 18 1/4"x18 7/8" (463mm x 480mm)
GATE OPENING 6" (152.4mm)
BOWL OPENING 6-5/8" (168.3mm)
TUBULAR RANGE 2-3/8", 2-7/8", 3-1/2"，4"，4- 1/2", 5”
MAXIMUM LOAD
165,000Lbs (80Ton)
CAPACITY
2. Section 2 – operation
Preparation
In order to operate the tubing spider correctly, the following step points should be prepared.
1. Choice suitable slip insert according to gripping pipe diameter and install correctly.
2. Check the outlet and inlet of cylinder make sure no any obstacles and connect hose to air resource.
3. Check the air pressure range, normally at 0.8 – 1.2 Mpa
4. The cylinder’s working pressure at 0.6 – 0.8 Mpa
5. Be sure to keep air source closing when lifting the slip with manual.
3. Section 3 –Installation
The TYPE C 80T AUTOMATIC SPIDER is easily installed on the rig floor. It can be used through pneumatic control panel. The TYPE C 80T AUTOMATIC SPIDER has lifting eye for pick up to rig floo
r.
乳糖操纵子Operation
1. Pull out of gate pins and gate from spider body then install the spider body
on correct position
2. Install gate pins and gate.
3. Supply air to tubing spider cylinder, slip body automatically lifted and
opened.
4. The tubing can be run down to hole.
5. Venting air through control panel, the slip will grip tubing automatically. Caution
蒋毅君 清华大学1. Be sure to keep hands and fingers away and out of all other areas when
handling tubing spider. Always make sure slip insert size match tubing diameter.
2. Always keep the safety latch in correct position
4. Section4–Maintenance
Inspection
To insure optimum performance from the tubing spider the following checks should be made once a week.
专利法1. Check inserts for even wear.
萍乡高专
教务管理系统2. Check for weak spring, cotter and pin on the slip and replace as necessary. 3. Check air circuit for operation normally, no any leakage of air.
4. If cracks are found during inspection, replace it.
Daily:
1. Springs, inserts, pins, screws and nuts
2. Check the link assembly and left/right hand, keep lubricating well.
豫公网安备41160202000603
站长QQ:729038198
关于我们
投诉建议