SESAM软件GeniE建模自学手册

ERITAS

曾国荃

D ET N ORSK

E V ERITAS

Define the guiding geometry needed to define the outer hull and deck levels Notice that the symbol for right mouse bottom click is different from left mouse bottom click

日本参议院选举Pages 14 -18•Part 4 –Make the deck plates

Create the deck levels and insert stiffening in between using both plates and beams Pages 19 –27

•Part 5 –Make the column

Insert the column between lower deck and above upper deck level Pages 28 –32

•Part 6 –Create the web frames

Insert three simple web frames and connect to the Pages 33 –34

•Part 7 –Column stiffening

Insert vertical stiffeners as well as a ring stiffener at top of column Pages 35 –38

•Part 8 –The crane

Model the crane using beams in order to apply the loads at end of crane tip Pages 39 –43

•

Part 9 –Boundary conditions

Insert pinned boundary conditions along all free edges and ensure that the simplified crane beam is connected properly to the shell column model by using linear dependencies Pages 44 –45

•

Part 10 –Loads

Create one loadcase with selfweight, another with 75 tonnes load at the crane tip and a load combination where loadfactor 1.6 is used on the crane load Pages 46 –48agagcl参比电极

Click start of beam 1Click end of beam

2Use right mouse button to activate the context sensitive menu心无旁骛抓落实

上栗论坛磺胺二甲嘧啶钠3

and select Material. Select Create/Edit Material to D ET N ORSKE V ERITAS

Find the right section library from “Browse”and select the library ‘tbar’(a library containing typical Tbar ship profiles)

D ET N ORSK

E V ERITAS

本文发布于:2024-09-22 19:33:32，感谢您对本站的认可！

本文链接：https://www.17tex.com/xueshu/257179.html

上一篇：在役双层海底管道试压难点分析

下一篇：电弧光保护系统说明书..