夜光Brinyte专业潜水手电筒DIV10说明书

夜光Brinyte专业潜水手电DIV10说明书
产品说明:
本潜水手电筒采用美国最新3CREE XM-L2 LED, 最高亮度达3000lumen, 磁控开关,不仅操作简单而且能够实现您对多种输出模式的要求,使用326650可充电锂电池高亮续航时间超过2小时,满足您在海底世界尽情畅游,12度的发光角度加上150米的潜水深度,会是您的潜水照明主力光源的最爱。
This canister dive light utilize three USA CREE XML-L2 LED, with max 3000 lumens output, magnetic switch, not only operate easily, also satisfy your multi mode output requirement, powered by 3*26650 lithium batteries, with max runtime is over 2 hours at high output.
Rated to the 150m depth underwater and three O-rings good seal construction, plus 12° excellent focus beam angle, it is one of the powerful primary lights for you to enjoy the amazing underwater world.
产品参数:
ANSI
高亮档
中亮档
低亮档
极低档
爆闪档
SOS
亮度
3000 流明
1800 流明
1200 流明
500 流明
3000 流明
/
续航时间
2.2小时
3.2小时
5.5自动上料系统小时
13小时
/
/
最大光强
26000坎德拉
最大射程
320
防跌落测试
1
防水等级
IP68水下150
注:以上参数是在实验室环境中测试所得,可能会随着手电的使用环境和电池不同而发生变化
Technical Parameters:
Output
连体滑雪服
High
Middle
Low
Very Low
Strobe
SOS
Lumens
3000 lm
1800 lm
1200 lm
500 lm
3000 lm破碎机锤头铸造工艺
/
Runtime
2.2h
3.2h
5.5h
13h
/
/
Intensity
26000cd
Distance
320m
Drop Resistant
1m
Waterproof
IPX-68(under water 150m)
The parameters above have been tested under laboratory conditions, so they may vary between different batteries and environments.
产品规格:
-采用美国进口CREE XM-L2 U2 LED 灯珠,寿命50000小时;
-使用326650可充电锂电池;
-高效横流稳压电路,亮度恒定;
-过热保护,防止外壳温度过高,延长电筒使用寿命;
-低压警示,当电池电量剩余过低时闪光提醒用户及时更换电池;
-反极性保护功能,防止因电池反装而损害手电;
-电池筒身磁控开关,操作方便;
-三层防水圈设计,潜水深度达150米;
-航空铝材并采用军工三级硬质阳极氧化抗磨和抗腐蚀处理,经久耐用
-采用镀膜防刮花钢化玻璃;
-光学分析设计的铝合金反光杯;
-产品尺寸:头部规格:长75.5*直径66mm;电池筒规格:长258*直径35mm
-配件:O圈,支架,说明书,润滑油和中性黑盒包装;
-其他可选配件:礼盒,电池,充电器。
Product Specification:
空调消声器
-Utilize 3*Cree XM-L2(U2) LED, lifespan is over 50,000 hours;
-Uses 3*26650 li-ion rechargeable batteries;
-High efficiency constant current circuit, constant brightness;
-Protect from overheat to prevent high shell temperature, extend flashlight lifespan;
-Low voltage warning function to remind the user to change the batteries;
- Reverse polarity protection to protect from wrong battery installation;
-Magnetic switch, very easy to operate;
-Three O rings design to ensure underwater 150 meters;
-The crust is made of durable Aircraft-grade aluminum;
硫芴
-Premium type III military hard-anodized finish for abrasion and corrosion resistance.
-5mm Toughened glass can stand higher water pressure resistance
- Alloy aluminum reflector
-Dimensions:
Head:66mm(D)*75.5mm(L)Battery Canister35mm(D)*258mm(L)
-Standard accessories: 3 spare O-rings, bracket, user manual, lubricant and neutral black box;
-Other accessories (optional): gift box, batteries and charger.
产品分解图及说明:
Products structure and instruction;
操作说明:
a) 电池安装
电池正极对准电池筒磁控开关方向(如图),旋紧电池筒即可使用
b) 开关电源
磁控开关,按下开关电源进行换挡(磁控开关操作建议停留3秒左右进行换挡);
Operation:
a) Battery installation
Keep the battery positive pole direction same as the battery canister switch (as shown in the picture), tighten the battery canister to turn on the light.
b) Push the magnetic switch to turn on/off the light and changed mode.
注意事项:
1)所有潜水电筒的连接处(除开关部位)在出货前都会密封,用户请不要擅自打开;
2)为了避免进水的可能,我们建议潜水前就打开电筒(开关一定拧紧);
3)避免水下多次拧动;
4)手电长时间不用,需将电池取出,否则可能因电池漏液或者爆炸造成手电损害。
5)为了避免磁控开关失灵,请注意将电筒远离消磁物品及场所
Note:
1) To ensure the magnetic switch work normally, please keep the light away from any magnetic goods,iron things and etc.
2) All of the connections (except the switch) are sealed before shipment, PLEASE don’t disassemble;
3) Avoiding the possibility of the dive light leak underwater, we suggest to tighten the switch before diving.
4) Please take the batteries out of the light if you don’t use it for long time, or the light may be damaged by the battery leakage or detonation.
手电保养:
1)每次潜水后请及时用淡水浸泡电筒;
2每次使用之后开关部分建议擦润滑油;
3请勿将电筒放在沙地上,以防细沙进入开关和螺纹缝隙;
4)请经常检查O圈,如有损害请及时更换,以维持手电的防水性能;
5)请经常清洁手电的导电接触面以保证手电的正常工作。
Flashlight maintenance:
1) Please immerse the dive flashlight in the fresh water for few minutes after diving and clean the water after immersing;
2) Please put lubricant on the switch threads after diving
3) Please don’t drop or place your dive flashlight in sand, in case the sand go into the magnetic switch and threads第n个空间
4) Please inspect the O-rings often, change a new one once anyone is damaged.
5) Please clean the conductive connections often to ensure the flashlight work normally.
手电常见问题自我检测:
当手电出现异常闪烁或者无法工作的时候,请按以下方式自我检测:
1) 电池电量不足---需要更换电池;
2) 螺纹或者PCB板的导电接触面被弄脏---请用酒精清理接触面

本文发布于:2024-09-22 17:25:13,感谢您对本站的认可!

本文链接:https://www.17tex.com/tex/4/232215.html

版权声明:本站内容均来自互联网,仅供演示用,请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系,我们将在24小时内删除。

标签:电池   开关   手电
留言与评论(共有 0 条评论)
   
验证码:
Copyright ©2019-2024 Comsenz Inc.Powered by © 易纺专利技术学习网 豫ICP备2022007602号 豫公网安备41160202000603 站长QQ:729038198 关于我们 投诉建议