CHIP TYPE, HIGH VOLTAGE, 3000 HOURS LOAD LIFE
貼片式，3000小時，高壓長壽命品
Operating with wide temperature range -40~+85°C
適用於 -40~+85°C的寬溫範圍
Load life of 3000 hours
負荷壽命3000小時
RoHS & REACH compliant, Halogen-free
符合RoHS與REACH，無鹵
贴片铝电解电容Items 項目Characteristics 主要特性Operation Temperature Range 使用温度範圍-40 ~ +85°C
Voltage Range 額定工作電壓範圍160 ~ 450V
Capacitance Range 靜電容量範圍 3.3 ~ 100μF Capacitance Tolerance 靜電容量允許偏差±20% at 120Hz, 20°C
Leakage Current 漏電流Leakage current ≤0.04CV + 100μA, whichever is greater (after 2 minutes application of rated voltage at 20°C) 漏電流 ≤0.04CV + 100μA，取較大值（在20°C環境中施加額定工作電壓2分鐘後）
C: Nominal capacitance (μF) 標稱靜電容量, V: Rated voltage (V) 額定電壓
Dissipation Factor (tan δ) 損耗角正切Measurement frequency 測試頻率: 120Hz, Temperature 温度: 20°C
Rated Voltage (V) 額定工作電壓160 ~ 250 400, 500
tan δ (max.) 最大損耗角正切 0.20 0.25
Stability at Low Temperature 低溫特性Measurement frequency 測試頻率: 120Hz
Rated Voltage (V) 額定工作電壓160 ~ 250
400, 500
Impedance Ratio 阻抗比
ZT/Z20 (max.)
Z(-25°C) / Z(20°C) 2 4
Z(-40°C) / Z(20°C) 6 10
Load Life
高溫負荷特性
After 3000 hours application of the rated voltage at 85°C, they meet the characteristics listed below.
在85°C環境中施加額定工作電壓3000小時後，電容器的特性符合下表的要求。 Capacitance Change 靜電容量變化率 Within
±
20% of initial value 初始值的±20%以內
Dissipation Factor 損耗角正切200% or less of initial specified value 不大於規範值的200%
Leakage Current 漏電流initial specified value or less 不大於規範值
Shelf Life
高溫貯存特性
After leaving capacitors under no load at 85°C for 1000 hours, they meet the specified value for load life characteristics listed above.
在85°C環境中無負荷放置1000小時後，電容器的特性符合高溫負荷特性中所列的規定值。
Resistance to Soldering Heat
耐焊接熱特性
(Please refer page 23 for soldering conditions)
(焊接件請查閱第23頁)
After reflow soldering and restored at room temperature, they meet the characteristics listed below.
經過回流焊並冷卻至室溫後，電容器的特性符合下表的要求。
Capacitance Change 靜電容量變化率Within
±10% of initial value 初始值的±10%以内
Dissipation Factor 損耗角正切initial specified value or less 不大於規範值
Leakage Current 漏電流initial specified value or less 不大於規範值
Marking 標識Black print on the case top. 鋁殼頂部黑字印刷。
DRAWING 外形圖 (Unit: mm)
DIMENSIONS (Unit: mm) 尺寸表
∅D x L 10 x 13.5 12.5 x 13.5 12.5 x 16 16 x 16.5
A 3.3 4.9 4.9 5.8
B 10.4 13.0 13.0 17.0
C 10.4 13.0 13.0 17.0
E ± 0.2 4.7 4.7 4.7 6.4
L 13.5 13.5 16.0 16.5 z A pressure relief vent is attached to products over ∅D=12.5
∅D=12.5以上產品有緩壓防爆閥
正極
負極
ALUMINUM ELECTROLYTIC CAPACITORS 鋁電解電容器
Series
CP
ALUMINUM ELECTROLYTIC CAPACITORS 鋁電解電容器
DIMENSIONS & MAXIMUM PERMISSIBLE RIPPLE CURRENT 規格尺寸及最大允許紋波電流 Coefficient 系數0.75 1.00 1.35 1.57 2.00
The endurance of capacitors is reduced with internal heating produced by ripple current at the rate of halving the lifetime with every 5~10°C rise. When long life performance is required in actual use, the rms ripple current has to be reduced. 鋁電解電容器在疊加紋波電流後會引起發熱，溫度每上升5~10°C壽命會減半。若要保持長壽命性能，請在使用過程中適當降低紋波電流。
豫公网安备41160202000603
站长QQ:729038198
关于我们
投诉建议