陶瓷灯头
江苏华强模具科技有限公司
学生姓名:
指导教师:
二〇一四年八月
摘要
棉籽皮
本设计说明书介绍了上汽集团某型号商用车8号横梁加强板的冲压模具设计过程。首先根据该覆盖件的结构特点,利用CAD和CAE技术,对该零件进行了全面的冲压工艺分析,接着制定了合理的工艺方案,在设计工艺方案的过程中重点介绍了拉深工艺的设计过程,其中主要包括拉深方向的选择、工艺补充面的设计、压料面的设计和拉深筋的设计。最后根据已定的挤出机螺杆
工艺方案,利用UG步进式开水机软件完成了拉延模、修边冲孔模和侧整形模这三套模具的结构设计。
关键词:汽车覆盖件,CAD,CAE,工艺补充,拉延模。
冯代存Abstract
The design specification describes a model number of commercial vehicles SAIC 8 beam stiffeners stamping die design process. Firstly, according to the structural characteristics of the cover, the use of CAD and CAE technology, the components of a comprehensive analysis of the stamping process, and then developed a reasonable process solutions. In the course of the program's design process focuses on the process of drawing the design process, which mainly include the drawing direction of choice addendum design, design and design drawbead binder surface. Finally, according to the process scheme has been set, using UG software to complete the drawing die, punching die design and side trimming plastic mold co three mold.
Keywords: auto cover, CAD, CAE, addendum, drawing die.