NT7534
132 X 65 RAM-Map STN LCD
Controller/Driver
220v交流
稳压器V1.0
Revision History (3)
Features (4)
General Description (4)
Pad Configuration (5)
Block Diagram (6)
Pad Descriptions (7)
Functional Descriptions (12)
Commands (27)
Command Description (43)
Absolute Maximum Rating (46)
Electrical Characteristics (46)
Microprocessor Interface (for reference only) (55)
Bonding Diagram (62)
Package Information (67)
Ordering Information (68)
Revision History
NT7534 Specification Revision History
Version Content Date
1.0 Released Dec. 2004
Features
132 x 65-dot graphics display LCD controller/driver for black/white STN LCD
RAM capacity: 132 x 65 = 8,580 bits
8-bit parallel bus interface for both 8080 and 6800 series,
4-wire Serial Peripheral Interface (SPI)
Direct RAM data display using the display data RAM.
When RAM data bit is 0, it is not displayed. W hen RAM data bit is 1, it is displayed.
(At normal display)
电力线适配器Many command functions: Read/Write display data, display ON/OFF, Normal/Reverse display, page address set, display start li
ne set, LCD bias set, electronic contrast controls, V0 voltage regulation internal resistor ratio set, read modify write, segment driver direction select, power save.
Other command functions:尼龙扣
Partial display, partial start line set, N-Line inversion.
Power supply voltage:
- VDD = 1.8 ~ 3.6 V
- VDD2 = 1.8 ~ 3.6 V
- V0 = 4.0 ~ 14.2 V
led
电子灯箱控制器
- VOUT = 14.2 V Max.2X / 3X / 4X / 5X on chip DC-DC converter
On chip LCD driving voltage generator or external power supply selectable
64-step contrast adjuster and on chip voltage follower
喷射
装置msisdn
On chip oscillation and hardware reset
General Description
The NT7534 is a single-chip LCD driver for dot-matrix liquid crystal displays, which is directly connectable to a microcomputer bus. It accepts 8-bit parallel or serial display data directly sent from a microcomputer and stores it in an on-chip display RAM. It generates an LCD drive signal independent of the microprocessor clock.
The set of the on-chip display RAM of 65 x 132 bits and a one-to-one correspondence between LCD panel pixel dots and on-chip RAM bits permits implementation of displays with a high degree of freedom. The NT7534 contain 65 common output circuits and 132 segment output circuits, so that a single chip of NT7534 can make maximum 65 x 132 or 49 x 132 or 33 x 132 dots display with the pad option (DUTY1, DUTY0).
No external operation clock is required for RAM read/write operations. Accordingly, this driver can be operated with a minimum current consumption and its on-board low-current-consumption liquid crystal power supply can implement a high-performance handy display system with minimum current consumption and the smallest LSI configuration.
Pad Configuration